Owner`s manual

10. Factory Re-Set (found under “Settings”): Use the pq and the Select buttons to initiate a

factory re-set. If you choose Yes, a message will ask you to conﬁrm this choice. A factory

re-set will erase all presets, language selection, Favorites, date, clock, alarm, WiFi security

password (if applicable), EQ settings, and any other customized settings. In the rare event you

encounter an operational problem, unplug the NetWorks for a few seconds and plug it back in.

If this fails to cure the problem, try the factory re-set.

11. Info (found under “Settings”): This shows information about your NetWorks radio which you

might be asked to provide should you phone or email with questions about software or repair.

This differs from the Info button on the remote control.

12. Software Upgrade (found in the main menu under “Internet Setup” in Internet radio

mode only): A message will appear automatically in Internet radio mode advising you when

new software is available. Otherwise, to check to see if an Upgrade is available, access the

“Internet Setup” in the main menu in Internet radio mode and select “Software Upgrade”. It is

recommended you check for a software Upgrade after completing initial set-up of your NetWorks

to be sure its software is fully up-to-date. Several different Upgrades might be necessary.

The NetWorks will automatically re-boot after a successful upgrade. In the unlikely event you

experience any odd behavior after a software upgrade, perform a factory reset.

WARNING: It is vital the NetWorks not be powered off or unplugged during the

software Upgrade process or else the radio will require servicing to restore operation.

How to set the Alarm:

1. Press the Alarm button on the remote or enter the Alarm menu under “Settings”. The Alarm

button on the remote will access the alarm menu even when the NetWorks is off.

2. Select Alarm 1 or 2.

3. Select “Time”. Adjust the hours with the pq buttons and press Select to save and repeat

the process for the minutes. You will see a message conﬁrming the alarm time and alarm has

been set.

4. Select the same alarm again to change the other options such as to set the alarm on or off,

Schedule (whether you want the alarm to sound every day (“Daily”) at the set time, or only on

weekdays, only on weekends or just once); the source you wish to wake to, the volume level

of the alarm (set by the pq buttons not the Volume button); and select “Save” to store the

changes.

Note: You must select “Save” after making any changes or else the changes will not

be saved in memory.

5. IfyouaccessthealarmmenuwhiletheNetWorksisoff,onceyou'venishedmakingandsav-

ing you’re adjustments, press the alarm button again or the left arrow button (t ) to return the

NetWorks to off mode.

Alarm Quick Set:Ifyoudon'tneedtochangeanysettingsinthealarmmenuandjustwanttoset

the alarm to wake, press and hold the Alarm button on the remote control to set Alarm 1. Press

and hold again to set Alarm 2. Press and hold again to set both Alarm 1 and 2. Or press and hold

a fourth time to cancel both alarms.

During a power outage, the alarm time(s) and clock will be maintained by an integrated back-up

memory. However, if power is lost during the same time the alarm is set to activate, the alarm

cannot activate.