Owner`s manual

6 – ENGLISH
Packed with your PAL BT you should find:
• One (1) AC power supply
• One (1) Nickel Metal Hydride battery pack (installed)
Please contact your dealer or Tivoli Audio if any of these items are missing.
Tivoli Audio, LLC
Seaport Center
70 Fargo Street, Suite 900
Boston, MA 02210 USA
1.877. 297.9479 (US Only)
1.617.345.0066
www.tivoliaudio.com
[e-mail]
Before you begin:
For your safety, the PAL BT is shipped from the factory with discharged batteries. However, it
is normal if the PAL BT plays straight out of the box. With the unit off, connect the power supply
to the PAL BT and plug it into a wall outlet to charge the batteries. (See “Fast Charge Mode”).
Like many rechargeable devices, there may be a delay before the LED starts to blink when
the PAL BT is brand new and first plugged in, or when left unused for several weeks. This
is a feature of the Power Management System designed to protect the batteries from
damage. Should you experience this, you may “jump start” the “Fast Charge Mode” by
playing the PAL BT (while plugged in) for approximately 2-3 hours and then turning it off
(but still plugged in). The green LED should begin to flash at that time indicating Fast Charge
Mode is active. In order to complete the charge cycle, leave the PAL BT plugged in for an
additional 4-5 hours even if the LED has stopped blinking.
Bear in mind it may take up to 4 charge/discharge cycles before the batteries are operating
at full capacity when the PAL BT is new or has been unused for several weeks.
Leaving the PAL BT plugged in even when not in use ensures the batteries will be charged
when you need it. If the PAL BT is not plugged in, the batteries will gradually self-discharge
as a safety measure. There is also no harm in playing the PAL BT continuously while
plugged in.
Jump Start
In the event there is no power from the battery after giving it a full charge, the battery may
have self-discharged. In this case, try this simple procedure:
1. Play the PAL BT at moderate volume for 3 hours while connected to the external adapter.
2. After 3 hours, switch the PAL BT off. The green power LED should begin to flash
indicating the battery is charging.
3. When the LED stops flashing, keep the PAL BT switched off but leave it plugged into
the external adapter for an additional 4-5 hours to complete the charging process.