Operation Manual

12 – ENGLISH

7. FACTORY RESET (FOUND UNDER SETTINGS): Press Select and use the pq or tu and

Select buttons to conﬁrm (Yes) or reject (No) the factory reset. A factory reset will restore factory

defaults and cancel all your personal settings, such as presets and language. Also see the

section marked “Digital Radio/FM Reception”.

8. ID (FOUND UNDER SETTINGS): Press Select to view the ID. If you contact your dealer or

Tivoli Audio with a question, you may be asked to provide the number shown in this ﬁeld.

9. SLEEP (FOUND UNDER SETTINGS): Press Select and use pq and the Select buttons to

set the sleep timer to one of the available times. There is also a dedicated Sleep button on the

remote control. A small clock face will show on the display when the Sleep timer is active.

HOW TO SET THE ALARM

10. With the Model 10+ powered on, Access the alarm setting either through the main menu or by

pressing the alarm button on the remote.

11. Alarm 1 is shown ﬁrst. Press the Alarm button repeatedly or use the pq and Select buttons

to choose between Alarm 1 and Alarm 2. Note: At any point you can navigate through the alarm

menu by using the Back or left arrow buttons, and the Select or right arrow buttons.

12. Use the pq and Select buttons to set the alarm on or off. If the time and date are not set

the Model 10+ will prompt you to set Time/Date. Otherwise, set the alarm as described in the

next step.

13. Use the pq buttons to set/change the hour, then press Select. Repeat this process to set/

change the minutes, followed by AM/PM (if time is set to 12 hour format), then press Select.

14. Use the pq buttons to select how long you want the alarm to sound, then press Select.

15. Use the pq buttons to select the source you wish to wake to, then press Select. If you set

the source to DAB (includes DAB+/DMB) or FM, use the pq buttons to select the station pre-

set (if presets have been stored) or last listened, then press Select.

16. Use the pq buttons to set how often the alarm should be set to wake, then press Select.

If “Once” is selected, you must set the date you wish the one time alarm to sound.

17. Lastly, use the pq buttons to set the volume level of the alarm, then press Select.

18. Repeat this process for Alarm 2 if desired.

If you make a mistake at any point in the process, press the Back button on the remote and

begin again.

Note: Your settings will not be saved unless you complete the entire process and the display

shows “Alarm Saved”.

Note: If you set the alarm source to DAB and the last listened or preset station is unavailable at

the time the alarm sounds, the alarm will default to the tone.

Power Loss: Should power be lost, or the Model 10+ becomes disconnected, the alarm time

will be saved but the Model 10+ alarm cannot sound if there is no power.

Alarm Quick Set: With the Model 10+ in standby, repeatedly press the alarm button brieﬂy to

toggle each alarm on or off.