Owner's Manual

7 – ENGLISH

Guide To Features (Front Panel)

1. POWER: Push to power the Music System+ On or Off (Standby).

2. VOLUME/MENU/TREBLE: Rotate clockwise to increase the volume or counter-clockwise to

decrease the volume. The volume level is represented in numbers from 0 (no output) to 30

(maximum output). If the volume ever sounds distorted, reduce the level immediately. In DAB

and FM modes, push and hold the knob to access the menu. See the sections marked “DAB

Menu” and “FM Menu”. Push brieﬂy and rotate counter-clockwise to reduce the treble or

clockwise to increase the treble. Press the volume knob in to set or the setting will store auto-

matically and the display will return to its previous state. This knob is also used to adjust and

enter selections (by pushing the knob in) when setting the Clock and Alarms. Adjusting the

volume during Snooze will cancel the Snooze mode.

3. ALARM 1/ALARM 2: Brieﬂy press and hold Alarm 1 or 2. A beep will conﬁrm you are in the alarm

set-up mode and the corresponding green LED will illuminate. Rotate and press the Volume knob

in to adjust and set the hour (Figure 1) and minutes (Figure 2) and press in to set and move to the

next setting. Note, adjusting the hour does not affect the minutes and vise-versa. Set the alarm

source (Figure 3 and 4) and alarm volume (Figure 5) in the same manner. Setting the alarm source

to “AUX” will cause the alarm to wake to a tone. You will not be able to set the alarm source to CD

if a CD isn’t loaded inside. Bluetooth

cannot be selected as an alarm source. When the alarm LED

is off, press the Alarm button once to set the alarm. The display will show the time the alarm is set

to wake. When the alarm LED is on, press the Alarm button brieﬂy to turn it off. If the alarm is set

and power is lost, the alarm will still sound (the tone will sound in place of radio or CD) at the des-

ignated time provided fresh batteries are correctly installed in the rear battery compartment. When

the alarm activates (Alarm LED ﬂashes) you may either turn the unit off and keep the alarm set for

the next day, press the Snooze button to temporarily mute the alarm for 7 minutes, or brieﬂy press

the Alarm button to cancel activation, turning the unit off, and keeping the alarm set to wake the

next day. Adjusting the volume during Snooze will cancel Snooze mode. CLOCK: Press and hold

to set. A beep will conﬁrm you are in the clock set mode. Use the volume knob to select the

hour (Figure 6) and then press the volume knob in to set and cycle to the minutes (Figure 7).

Adjusting the hour does not affect the minutes and vise-versa. Repeat this process to set the

year, month and the day (Figure 8, 9 and 10). Once set, press the Clock button brieﬂy to recall

the date and time whenever DAB, RDS or CD Text is displayed. When the date is shown, only

the month and day will show (not the year).