Owner's Manual

8 – ENGLISH
4. CLOCK: Press and hold to set. A beep will confirm you are in the clock set mode. Use the
volume knob to select the hour (Figure 6) and then press the volume knob in to set and cycle
to the minutes (Figure 7). Adjusting the hour does not affect the minutes and vise-versa. Repeat
this process to set the year, month and the day (Figure 8, 9 and 10). Once set, press the Clock
button briefly to recall the date and time whenever DAB, RDS or CD Text is displayed. When
the date is shown, only the month and day will show (not the year).
5. PRESETS 1–6: Press and hold to memorize the tuned station to that particular preset. A beep
will sound confirming the station has been successfully stored. Press briefly to recall the sta-
tion associated with that preset. There are 6 DAB presets and 6 FM presets. If a Preset button
is pressed but no station has been set, the display will show “Preset Empty” for 2 seconds.
These buttons will also act as limited direct track access during CD playback. The same sta-
tion cannot be saved to more than 1 preset.
6. SOURCE/BT: Briefly press to cycle through the sources: DAB, FM, CD, Bluetooth/Auxiliary. The
source can’t be changed while the alarm is sounding. If the source is changed during CD play-
back and the source is changed back to CD again, the CD will start playback from the first track.
7. SLEEP: With the Music System+ playing DAB, FM, CD, Bluetooth or an auxiliary device, briefly
press to begin the 20 minute Sleep timer. The corresponding green LED will illuminate while the
Sleep timer is active and the display will countdown the remaining Sleep time. The Music
System+ will power off automatically at the end of the Sleep cycle. Sleep cannot be activated
in CD mode unless a CD is loaded. Note DAB, RDS and CD Text will not be displayed in Sleep
mode.
8. / TUNE
+
/
– :
In DAB mode, press to access and navigate the DAB Station List. The
volume knob may also be used to navigate when in the Station List. Press the volume knob in
to tune a DAB station or press the “Enter” button on the remote. The Music System+ will return
to the last-tuned station if no action is taken in the Station List after 3 seconds. Note the volume
knob will not control the volume level when in the DAB Station List.
FM: Press the Tune +/- buttons briefly to Auto Scan to the next station detected. See “Scan
Setting” under “FM Menu” on how to disable Auto Scan and tune stations manually.
CD: Briefly press to advance to the next track on a disc or back to a previous track if the track
has been playing for under 10 seconds. If the track has been playing for more than 10 seconds,
Fig 1, 2, 3, 4, 5
Fig 6, 7, 8, 9, 10