User Manual

Alarm Off: To stop the alarm, press the Alarm or Power button on the remote.
Snooze: To activate Snooze, press the Snooze button on the remote. The Snooze time
is not adjustable. When operating on battery-only power, pressing Snooze will have no
effect.
Note: When in Snooze mode, you can see the remaining Snooze time by pressing the
Snooze button on the remote. If you press the Alarm or Power button on the remote, then
the Snooze countdown will be cancelled and the PAL
+BT
will go into Standby or off if
operating on battery-only power.
Digital Radio (DAB/DAB
+
/DMB) Mode
STATION LIST: Use the pq buttons on the remote to show all available DAB/DAB
+
/DMB
stations. Use the pq buttons to highlight a specific station and the Select button to tune
that station. The Station list will disappear after 7 seconds.
Press and hold the Menu button on the remote to enter the main menu. Use the pq but-
tons and the Select button to change the items within the menu. Use the Back button to
navigate back, or wait for 15 seconds until the timeout expires.
An asterisk (*) indicates the shown menu item is currently set.
Note: Upon entering Digital radio mode, if the Station list is empty, a full scan will initi-
ate.
1. FULL SCAN: Searches the entire frequency range. If you move the PAL
+BT
to another
location, you must perform a new scan so the radio will find stations in the new location.
To cancel the auto scan, press the Back button on remote.
2. EQUALIZER: Please refer to the section marked “Menu and Specific Features”.
3. MANUAL TUNE: Press the pq buttons to manually tune specific DAB/DAB
+
/DMB
frequencies, then press Select to tune the displayed frequency.
4. DRC: Dynamic Range Control allows you change the sound level of stations to make
quiet passages louder to compensate for a noisy environment, or when listening at a
low volume level.
5. ADVANCED MODE: If the PAL
+BT
is relocated to a different area, you may find stations
with the same name. If you enable “Advanced View”, “Long labels”, and “Show Ensemble”
under Advanced Mode, you will be able to differentiate between extended station names.
For DAB/DAB
+
, we suggest disabling all the Advanced Mode settings. For DMB, we
suggest enabling them.
6. PRUNE: If the PAL
+BT
is relocated to a different area, some stations may become
unavailable. Select “Prune” to remove unavailable stations from the Station list. Use the
pq or t u buttons and the Select button to confirm (Yes) or deny (No) removing
unavailable stations.
NOTE: When moving the PAL
+BT
to another location where there may be different
DAB stations from the previous location, it is recommended to run a “Prune” to remove
unavailable stations.
DAB DISPLAY MESSAGES:
Secondary Services: Secondary stations will be indicated by a >> symbol next to the
14 – ENGLISH