Operation Manual

34
12.3.2 Configure Ethernet Connection
Gigabit Ethernet can be also used to connect wired network. Connect the network cable at
the Ethernet network port at rear side of the unit.
1) Select <Settings Browser>  <Network>  <Ethernet connection>.
2) If the configuration is “Auto IP”, the network connection will occur immediately.
3) Otherwise, network setting should be manually configured by selecting <Ethernet
Settings>.
12.3.3 Configure Manual-IP Ethernet
To configure the manual-IP, select “Manual IP” like following picture then select “Next”
button.
The following dialog box will appear. Enter the each digit by pressing number buttons on
remote controller. Or you can use the mouse to enter the number. The virtual keyboard will
appear if you click the field to enter.