Product Manual

XCHANGE
R
TM
DT2-6 6” DUCT TAKE OFF KIT
WARNING: Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equip-
ment to prevent backdrafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those
published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and
Air Conditioning Engineers (ASHRAE), and the local code authorities.
WARNING: Do not exhaust air from mechanical room unless makeup air is also supplied or equipment in mechanical room is sealed
combustion. Carbon monoxide poisoning may result. Use the DT2-6 kit so exhaust can be removed from outside the mechanical
room if necessary. The DT2-6 can also be used to duct air to a room where the X
CHANGER
TM
is not installed in.
Disconnect power supply to fans and/or control when installing the DT2-6. Failure to do so may result in personal injury and/or equipment damage.
© 2010 Tjernlund Products, Inc. All rights reserved. P/N 8504165
TJERNLUND PRODUCTS, INC.
1601 Ninth Street • White Bear Lake, MN 55110-6794
PHONE [phone] • [phone] • FAX [phone]
Visit our web site • www.tjernlund.com
Remove (4) screws and remove
rear plate from XCHANGER
TM
.
Install DT2-6 on rear of
XCHANGER
TM
with (4) screws
removed previously.
Install 6” rigid, flexible or insulated flexible duct on DT2-6 take off.
Firmly secure duct to take off with included zip ties. Insulated flex
should be used in cold climates where supply air is brought in to pre-
vent condensation. Properly support duct to minimize sagging, bends
and sharp turns that may restrict air flow.
XCHANGER
TM
DT2-6 6” DUCT TAKE OFF KIT
WARNING: Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equip-
ment to prevent backdrafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those
published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and
Air Conditioning Engineers (ASHRAE), and the local code authorities.
WARNING: Do not exhaust air from mechanical room unless makeup air is also supplied or equipment in mechanical room is sealed
combustion. Carbon monoxide poisoning may result. Use the DT2-6 kit so exhaust can be removed from outside the mechanical
room if necessary. The DT2-6 can also be used to duct air to a room where the X
CHANGER
TM
is not installed in.
Disconnect power supply to fans and/or control when installing the DT2-6. Failure to do so may result in personal injury and/or equipment damage.
© 2010 Tjernlund Products, Inc. All rights reserved. P/N 8504165
TJERNLUND PRODUCTS, INC.
1601 Ninth Street • White Bear Lake, MN 55110-6794
PHONE [phone] • [phone] • FAX [phone]
Visit our web site • www.tjernlund.com
Remove (4) screws and remove
rear plate from XCHANGER
TM
.
Install DT2-6 on rear of
XCHANGER
TM
with (4) screws
removed previously.
Install 6” rigid, flexible or insulated flexible duct on DT2-6 take off.
Firmly secure duct to take off with included zip ties. Insulated flex
should be used in cold climates where supply air is brought in to pre-
vent condensation. Properly support duct to minimize sagging, bends
and sharp turns that may restrict air flow.