User's Manual

- Restore

- Set Access Right (All Time/One Time/By Duration)

- Set Client Nick-names

 View Audit Trail

 Check Lock Battery status

 Update Lock Firmware

 Gateway Management

5. Card Operations

Card Unlocking

Put the card in front of the sensing area, and wait until LED flash and beep heard.

6. Low Battery Warning

When the battery is at a low state, there are two kinds of situation:

 LOW BATTERY: Once battery voltage level drops low, there will be 5 beeps + 5 red

following unlocking sound

 EXTREME LOW BATTERY: Once battery level drops lower continuously, the motor will

not be driven to unlock after authentication. There will be 10 beeps + 10 red

following unlocking sound

Both situations are only released by replacing with brand new batteries.

7. Return to Factory Default

Following the steps:

1. Remove battery holder and take-out one battery

2. Press the SETUP button and keep it pressed

3. Put the battery removed at step 1 back into the battery holder and wait for 5 seconds

(while SETUP button kept pressed)

4. After buzzer beeps once with green light, release SETUP button. All previous created

users and Admin will be deleted.

5. Put the battery holder back