Operation Manual

Content
Introducon ................................................................................................ 2
Installaon ................................................................................................... 4
Operaon .................................................................................................... 6
Warranty ..................................................................................................... 8
Appendix ..................................................................................................... 9
Introducon
Thank you for purchasing the TMG A-15, one of the most innovave and
sophiscated devices in its category today.
Please be sure to read this manual to familiarize yourself with the features and
operaon of this product. Enjoy the trip and drive safely.
TMG system is a class 1M laser product. Never look at the heads
closely while powered on! We recommend wearing Laser protected
eye wear, when tesng the jamming funcon with Laser guns.
Motorists are expected to exercise all cauon while using this
product, and to obey all applicable trac laws.
Check your State and local laws on usage. We encourage you to disable your
jamming funcon as soon as possible once you slow down. This can be done by the
RCV buon, front power buon, or the RCV tab on the app. Running in the “test
mode” is meant for laser jamming tesng only, and is in full me jamming mode,
and could result in suspicion that a LIDAR operator has been jammed. Auto-sleep
mode is default, and highly recommended with an Auto-kill feature to “Receive only
mode” aer 4 seconds.
CPU only takes 12V power sources; A 24V power source will damage
the product permanently, and will void your 2 year warranty.
Specicaons
Input .................................................................................. DC 12V
Laser Wavelength .............................................................. 905nm
Opcal Peak Power ............................................................ Up to 75 W
Communicaon ................................................................. BT3.0/4.0 Compable
Operaon Temperature .................................................... -10°F~150°F / -25°C~70°C
Tool Requirements
• T-10 torque bit or allen wrench
• Cordless screw driver- mount the brackets
• Small screws- to mount the brackets
• Velcro or 3m tape to mount the CPU
• Tape measure- measure out the head seperaon
• Electrical tape - wrap up the head connectors and the wire to
feed through the rewall.
• Metal wire to feed the wires through the rewall. (Oponal)
2 3
Indent
Set Screw
Detent
Coupler
Detent on transponder lines up with indent on the
bracket. Posion is locked into place with the set screw.