Model PS301SS00 Professional Series Refrigerated, Internet Controlled 30” Electric Built-In Single Wall Oven Installation Instructions Part No.
BEFORE YOU START ! CAUTION: Oven is heavy. Use care in handling. ! Proper Installation is your responsibility. Ensure the oven is electrically connected by a qualified electrical installer and conforms with the National Electrical Code, ANSI/NFPA 70 - latest edition, or in CANADA, Canadian Electrical Code, CSA C22.11982 and C22.2 No. 01982 - latest edition. ! Ensure that the oven is properly grounded. See Electrical Requirements (page 3) and Installation Steps: Step 3.
ELECTRICAL REQUIREMENTS i The Connect Io Intelligent Oven requires a separate, grounded 4-wire, 240V (AC), 50 Amp service with its own circuit breaker. IMPORTANT if location utilizes aluminum wiring: The electrical conduit must be kept to the top left for a flush installation. Never cut the conduit. • Connect the aluminum wiring to the copper wire using special connectors designed and UL listed for joining aluminum to copper.
PRODUCT DIMENSIONS Quick Reference APPROXIMATE SHIPPING WEIGHT: 350 lbs / 159 kg Oven Right View RJ45 network jack 120V outlets 39 1/8” (99.4 cm) overall height 37 5/8” (95.6 cm) recessed height Door extends 21” (53.3 cm) from cabinet face Door extends 44 1/2” (113 cm) from oven rear 23 1/2” (59.7 cm) recessed depth REFRIGERATION: Refrigeration ductwork is located at the rear of the oven and must not be damaged during installation.
Designed and manufactured in the USA with pride by TMIO, LLC • Chattanooga, TN • US toll-free +1.800.881.TMIO (8646) • www.tmio.com Connect IoTM, Intelligent OvenTM, Intelligent OvensTM, Green CleanTM, and TMIO® are registered trademarks of TMIO, LLC.
Designed and manufactured in the USA with pride by TMIO, LLC • Chattanooga, TN • US toll-free +1.800.881.TMIO (8646) • www.tmio.com Connect IoTM, Intelligent OvenTM, Intelligent OvensTM, Green CleanTM, and TMIO® are registered trademarks of TMIO, LLC.
INSTALLATION STEPS STEP 1. Unpacking the Oven j Make sure to TURN OFF the breaker for the oven power supply. ! CAUTION: Remove oven door, and remove the louvered refrigeration panel before removing unit from shipping pallet. Carefully remove all packing material from unit WARNING! THE OVEN SHOULD NEVER BE LAID ON ITS BACK OR SIDE. If the oven has been laid on its back or side, the oil in the compressor will need at least one (1) hour to drain back into the compressor before powering up the oven.
Designed and manufactured in the USA with pride by TMIO, LLC • Chattanooga, TN • US toll-free +1.800.881.TMIO (8646) • www.tmio.com Connect IoTM, Intelligent OvenTM, Intelligent OvensTM, Green CleanTM, and TMIO® are registered trademarks of TMIO, LLC.
INSTALLATION STEPS STEP 3. Electrical Connections ! ! i WARNING! ELECTRICAL SHOCK HAZARD! Turn OFF the household power supply breaker before connecting wires. The oven must be connected to a permanent and grounded supply. Failure to follow these instructions can result in death, fire or electrical shock. This oven requires a separate, grounded 4-wire, 240V (AC), 50 Amp service with its own circuit breaker. Installation must comply with National Electric Code. See “Electrical Requirements” (page 3).
Designed and manufactured in the USA with pride by TMIO, LLC • Chattanooga, TN • US toll-free +1.800.881.TMIO (8646) • www.tmio.com Connect IoTM, Intelligent OvenTM, Intelligent OvensTM, Green CleanTM, and TMIO® are registered trademarks of TMIO, LLC.
INSTALLATION STEPS STEP 6. Install Oven Into Cabinet ! WARNING! OVEN MUST BE SECURED INTO CABINET USING ATTACHMENT TRIM. Failure to do so can result in the oven tipping and falling out of the cabinet and cause personal injury or death. o IMPORTANT: Securely fasten the oven to the cabinet using the four (qty. 4) Phillips cabinet mounting screws provided. Insert the Phillips screws through holes in the oven vertical side trim. Do not over-tighten screws.
Designed and manufactured in the USA with pride by TMIO, LLC • Chattanooga, TN • US toll-free +1.800.881.TMIO (8646) • www.tmio.com Connect IoTM, Intelligent OvenTM, Intelligent OvensTM, Green CleanTM, and TMIO® are registered trademarks of TMIO, LLC.
INSTALLATION STEPS i STEP 8. Final Checklist j Make sure the oven is level, and securely fitted/ attached to the oven cabinetry. k Reinstall oven door. See “Door Attachment”. i l Make sure to remove all internal packaging from the oven cavity, and replace the oven racks. m Make sure all oven vents and openings, including the refrigeration panel, are clear and free of any obstruction.
3 3 CLEANING YOUR OVEN MORE INFORMATION Cleaning Tips & Precautions Other Tips & References OVEN INTERIOR Wash the interior of the Connect Io oven thoroughly with hot, soapy water to remove film residues and any installation dust or debris before use for food preparation. Follow this washing procedure by rinsing and wiping dry. Solutions stronger than soap and water are rarely needed.
Connect IoTM Intelligent OvenTM Model PS302SS00 Professional Series Refrigerated, Internet Controlled 30” Electric Built-In Double Wall Oven Installation Instructions Part No. 101206 © 2007 TMIO, LLC • +1.800.881.TMIO (8646) • www.tmio.com • 1220A Flynn St.