Integration Manual

Motion Detector User and Integration Manual
Revision A Page 9 Nielsen Confidential
If the host device is subject to other authorization procedures or parts, the
appropriate requirements of these authorization procedures or parts apply.
The end device must be labeled with the following statement:
Contains FCC ID: 2ASUZ003 (enter FCC ID on the Label)
6.2. Additional Testing
The host product manufacturer is responsible for compliance to any other FCC rules that
apply to the host not covered by the modular transmitter grant of certification. The final
host product still requires Part 15 Subpart B compliance testing with the modular
transmitter installed.
6.3. Instruction Manual
Regarding modification of equipment, the instruction manual of the host shall include the
following statement:
Changes or modifications made to this equipment not expressly approved by the
party responsible for compliance may void the FCC authorization to operate this
equipment.
The instruction manual of the host shall include the following statement:
For class B device:
FCC §15.105 (b):
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
Receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.