User's Manual

Page 10 – S5.5 Monitoring Software Manual Rev 1.2 for Software Ver 1.0
The panels indicate:
i. The RF signal level for both A and B
diversity channels. The bars are scaled
in micro-volts. A single red bar element
indicates the current mute level.
ii.
The audio VU level scaled in decibels
iii. Diversity LEDs labelled A and B indicating the
current receiver channel.
iv. The battery level.
When approximately one hour of life remains,
the indicator flashes red.
v. The name associated with the
performer/receiver.
vi. The operating frequency.
Below is a view of a single receiver panel from an 8-way display.
If you wish to change any of the parameters for a receiver, right click on the receiver panel in the main
display and a receiver detail panel will appear as below.
Note: Changes are only saved to file if either, the system is set to load a file at application start or
a file has been explicitly loaded in to the system using the ‘File’, ‘Load’ menu.
Should you use the receiver front panel to change the mute level or the tuned frequency, the PC display
will update but this change will NOT be saved to a file. If you wish to change the receiver frequency and
save the change to file, use the detail window as above.
i. Top line shows the file name.
ii. An actor or performer name can be entered into
the box on the next line.
iii. The box on the next line allows the frequency to
be set.
iv. Moving the slider sets the Mute level from 1 to 10.
The current Mute level is indicated by red markers
on the RF bar graphs.
v. Clicking ‘User Mute’ will toggle audio mute On/Off
for output from the selected receiver. The Mute
icon will be displayed in the output panel. as in the
12-way display above.
vi. Clicking OK saves the data to file.
vii. Cancel returns without saving.
viii. The receiver band is shown at the bottom.