User's Manual

Page 3 – S5.5 Monitoring Software Manual Rev 1.2 for Software Ver 1.0
2.1 Trantec USB driver installation for Windows XP
During installation, the USB driver files are copied to the ‘Trantec USB Driver’ folder within the ‘Trantec
S5 Monitoring’ program folder. For the USB system to work, every Trantec receiver must appear to your
PC as a unique device. For this reason it is necessary to load a driver for every receiver you wish to
use.
If you will be using more than one S5 Series receiver you should connect a USB 2.0 hub to a USB port
on your PC. (See ‘Appendix A’ for guidance on connecting a USB system).
i. Connect your first Trantec S5 receiver to the hub. The ‘Found New Hardware Wizard’ should
start after a short delay. If the following dialog appears, select ‘No, not at this time.’
Click ‘Next’.
ii. For the first receiver, select the option "Install from a list or specific location (Advanced)".
Click 'Next'.
Note: For any further S5 receivers you should select “Install software automatically
(Recommended)’ then click ‘Next’ and proceed as from ‘iv’ below.