SFX 5.1 manual AW.
SFX 5.1 manual AW.qxd:Layout 1 18/9/07 12:12 Page 2 Important safety instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with manufacturerʼs instructions. This apparatus is not suitable for in wall mounting. Introduction Thank you for purchasing this high performance 5.1 8.
SFX 5.1 manual AW.qxd:Layout 1 18/9/07 12:12 Page 3 If at any time during this warranty period the equipment proves to be defective for any reason other than accident, misuse, neglect, unauthorised modification or fair wear and tear, we will repair any such manufacturing defect or, at our option, replace it without charge for labour, parts or 14. Warning: To reduce the risk of fire or electric return carriage.
SFX 5.1 manual AW.qxd:Layout 1 18/9/07 12:12 Page 4 The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage " within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
SFX 5.1 manual AW.qxd:Layout 1 18/9/07 12:12 Page 5 5.1 system setup guide This high performance 5.1 system has been built and tested with care and precision, to provide first class performance and reliable operation. To ensure maximum benefit from ownership, and for reasons of safety, please read the following information before using for the first time.
SFX 5.1 manual AW.qxd:Layout 1 18/9/07 12:12 Page 6 Connecting the subwoofer to your system The SFX5.1 system subwoofer may be connected in any one of the following ways: Line levels • Using the subwoofer output on your A/V receiver or decoder connect a single RCA interconnect to either the left or right line input on the subwoofer rear panel. This is the ideal connection type as the sub woofer output contains the low frequency information from all channels.
SFX 5.1 manual AW.qxd:Layout 1 18/9/07 12:12 Page 7 Setting up Ensure the POWER switch is in the OFF position. You can operate the SFX subwoofer in two modes, AUTO and ON. Set to AUTO, the unit remains switched off until a signal is present (power saving), set to ON the unit runs continuously. Connect the SFX subwoofer to a convenient mains socket using the lead and Positioning plug supplied. As the SFX subwoofer produces low frequencies only, it is difficult to detect its location by ear.
SFX 5.1 manual AW.qxd:Layout 1 18/9/07 12:12 Page 8 Centre & Satellites PERFORMANCE Recommended amplifier power 15 - 100 Watts Maximum Sensitivity (2.83Volts @ 1m) 85dB Nominal impedance 6 Ohms Frequency response (-6dB) 140Hz - 78kHz Drivers HF: 15mm (0.59”) titanium dome, neodymium magnet system LF: 75mm (2.95”) paper cone Crossover frequency 4.5kHz (mid to high) 140Hz (to subwoofer) Magnetic shielding Yes Satellite Weight 750gms (1.