User Manual

9.3. Power Amplifier Panel Connection

• Use the same output line voltage when connecting power amplifier panels for parallel operation. You can

connect up to three power amplifier panels of the same kind in parallel.

Important: Make connection so that the total of speaker rated input power is less than 1 kW for a group of

five consecutive speaker lines (i.e. lines 1-5, 6-10, etc.).

• Do not use the 4 Ωoutput terminal for the rack PA system.

• Refer to p. 24 "Emergency Power Supply Panel DS-029B Connection" for details of the connection to the

emergency power supply panel.

• The junction panel's C1 and H1 are input terminals for speaker lines 1-5, and C2 and H2 are for speaker

lines 6-10. When the panel is supplied from the factory, the input terminals are short-circuited between C1

and C2 and between H1 and H2 by means of a jumper wire. Also, because the monitor circuit is connected

to between C1 and H1, the monitor panel is additionally required for monitoring speaker lines 6-10 when

using the input terminals by separating C1 and H1 from C2 and H2.

Supplied with power

amplifier panel.

Supplied with power amplifier panel.

Supplied with EP-0510.

Supplied with DS-029B.

Power amplifier panel rear panel

EP-0510 rear panel

DS-029B rear panel

JP-0410 rear panel