Owner's manual

6
Step 11. Mountthesafetywiresandstopperwire.
Forthesafetywiremountingmethod,refertotheoperatinginstructionssuppliedwiththeHX-7Bor
HX-7Wspeaker.
Wall
Safety wire
Stopper wire
Rear bracket
Note
Secure the safety wire to beams,
pillars or other strong structures.
Note
Mount to the rear bracket's idle hole.
Rear angle bar
Shackle
4. MOUNTING THE SPEAKER TO A CEILING
(using the optional HY-C0801 or HY-C0801W bracket)
MounttheHX-7BorHX-7WSpeakerSystemtoaceilingbyusingtheHY-VM7incombinationwiththeoptional
HY-C0801orHY-C0801WSpeakerCeilingMountingBracket.
Step 2. MountBracketAoftheHY-C0801orHY-C0801Wtoaceilingusingfourormorebolts.
Step 1. RemovethesafetyboltfromBracketAoftheHY-C0801orHY-C0801W,anddetachBracketB.
Tightentheboltssecurely,asinstructedbelow.
Failureto follow instructions precisely could result in a falling speaker
andpotentialpersonalinjury.
• Ensurethatallboltsaresecurelyinsertedasfarastheirthreadsgo,
then securely fasten each bolt with a nut.
• Tightenalltheboltswiththedesignatedtighteningtorque.
 Fortightening,useaPhillipsscrewdriver,oropen-orbox-endwrench.
WARNING
Ceilingmountingboltsandnutsarenotsupplied.
Usenutsandboltsthatareappropriatefortheceiling’sstructure
andcomposition.Failuretodosomaycausethespeakertofall,
resultinginpersonalinjury.
WARNING
Nut for M8
Safety bolt
Fixed nut
HY-C0801 or HY-C0801W
(Bracket B)
HY-C0801 or HY-C0801W
(Bracket A)
150 (5.91")
120 (4.72")
8 - ø11 (0.43")
Unit: mm
150 (5.91")
120 (4.72")
[Bracket A's mounting dimensions]
Horizontal angle
adjustment nut
Plain washer
Note
Be sure to use 4 mounting holes at 4
corners in Bracket A.