Owner's manual

7
Step 3. Attach the angle bracket of this bracket to the T-bracket.
Usefourofthesuppliedboltstosecure.
Step 4. MounttheHY-VM7’sT-bracketandanglebracket,andBracketBoftheHY-C0801orHY-C0801Wto
the speaker.
SubsequentproceduresarethesameasthosedescribedinSteps 2 to 4inthechapter,"MOUNTING
THE SPEAKER ON A WALL" (p. 3 and 4). However, read "HY-WM7B or HY-WM7W" as "HY-
C0801orHY-C0801W."
Step 5. FittheHY-C0801’sorHY-C0801W’sBracketBboltintothenotchofBracketA.
Inthisevent,axedwashermustbepositionedabovethenotch,andaplainwasherpositionedbelow
it.
Angle bracket
T-bracket
Hex head bolt M6 x 20 with spring
and plain washers (accessory)
Tightening torque: 8 N·m
Owingtothespeaker’ssizeandweight,besurethatatleasttwo
personsare availabletoinstalltheunit.Failuretodosocould
resultinpersonalinjury.
WARNING
Safety bolt
This bracket (T-bracket)
This bracket (Angle bracket)
HY-C0801 or HY-C0801W
(Bracket A)
Nut for M8
Plain washer for M8
Fixed nut
Horizontal angle
adjustment nut
Plain washer
HY-C0801 or HY-C0801W
(Bracket B)
5
7
8
6
HX-7B or HX-7W
Tightening torque:
8 N·m
Step 6. Insert the safety bolt into Bracket A of the
HY-C0801 or HY-C0801W, and tighten the
bolt securely with a nut.
Step 7. Adjustthespeaker’shorizontalangle.
Aftercompletingadjustment,tightenBracket
B’shorizontalangleadjustmentnut.
Horizontalangleadjustmentrange:
180°toleftandright(360°forentirecircumference)
Step 8. Settheanglebracket’sangleandsecurewithabolt.
SubsequentproceduresarethesameasthosedescribedinStep 10inthechapter,"MOUNTINGTHE
SPEAKERONAWALL"(p.5).
Step 9. Mountthesafetywires.
Forthesafetywire mountingmethod,refertotheoperatinginstructionssuppliedwiththe HX-7Bor
HX-7Wspeaker.