User Manual

16
5.3.2. Flow view
Displays the unit’s signal processing image by means of a signal ow consisting of Function and Level Meter
boxes, which indicate the unit’s signal processing operation, and a straight line connecting the input and output.
Signal input is at the left of the centrally located signal ow matrix box, and signal output at the right.
To change signal processing settings, click each of the signal processing function boxes. A pop-up sub-view is
displayed, permitting changes to be entered.
The selected function box is highlighted with an orange frame (except for the Level Meter box, which is shown
with a blue frame).
The following operations can be performed for each function box using the menu displayed by right-clicking
the box.
Data can be copied and pasted by dragging and dropping the box.
Copy: Copies the parameters set for the function box selected on the ow view to the clipboard.
Paste: Pastes the data in clipboard to the function box selected on the ow view.
Clear: Initializes the parameters set for the function box selected on the ow view.
Box Write Protect... :
Off: Sets no restriction on write to box.
Low: Restricts the operator from changing the parameters set in the box.
Mid: Restricts the operator from changing all settings in the box.
High: Restricts the administrator from changing the parameters set in the box, and the operator from
changing all settings in the box.
Note: The above operation cannot be performed on the Level Meter box.