Manual
20 21
Step 10. Enter information in the Comment column as required.
Step 11. Click the Interval pull-down menu to select the repeat interval as required. (Only the Sound Repeater
without an interval setting function)
Tips
• Theterm"Interval"referstotherepeatplyabackintervalthatrepresentsthetimebetweentheend
of the previous audio data and the start of the next audio data. Set delay times* are not added to the
repeat interval.
* Not all Sound Repeaters have this delay time setting function.
• Therepeatintervalisfactory-presetto"norepeat."
• Tostoprepeatbroadcastswhileinprogress,presseitherthePM-20EV'sPlaykeyortheStopbutton
on the PC's Sound Repeater Memory area.
Step 12. Repeat Steps 3 – 11 and program the audio data into all desired audio data areas.
Tips
• AudiodatacanalsobeprogrammedbydragginganddroppingWavefilesintheFilenamecolumn.
• Todeleteaprogrammedaudiodata,clicktheFilenamecolumnoftheaudiodatatobedeletedand
click the Clear button. A dialog box is then displayed. Click Yes after ensuring that the filename is
correct.
• Whenprogrammingasecondtimeorthereafter,thereisnoprocedurefordesignatingthefolder
save destination. Programmed data are automatically written into the first designated project name
folder.
Note
When the Sound Repeater is EV-20S, 4 audio data can be programmed into it, however, only 3
programmed audio data (No.1 – 3) out of them can be played back depending on the amplifier the
EV-20S is built in.
Interval Settings Setting Contents
no repeat (Factory-preset position) No repeat broadcasts.
0 sec Continuous broadcast with no intervals.
5 sec Broadcasts are repeated after each 5-second pause.
10 sec Broadcasts are repeated after each 10-second pause.
30 sec Broadcasts are repeated after each 30-second pause.
1 min Broadcasts are repeated after each 1-minute pause.
5 min Broadcasts are repeated after each 5-minute pause.
10 min Broadcasts are repeated after each 10-minute pause.
30 min Broadcasts are repeated after each 30-minute pause.
1 hour Broadcasts are repeated after each 1-hour pause.