User guide

4
Φ48
Φ30
37
260
Lock ring
BATTERY
Power
indicater
6. HOW TO INSERT BATTERIES
Note
Minimizethevolumeofthemixeroramplierconnectedto
thereceiverbeforeopeningorclosingthecase.
Step 1. Rotatethelockringinthearrowdirectionshownat
right, then pull the battery case down to open the
battery compartment.
Step 2. Turn off the power switch.
Step 3. Insert two AA batteries noting correct polarity.
Step 4. Replacethebatterycase,andlockthelockring.
The operation section is backlit while the battery case is
open,anditslightgoesoutwhenclosed.
[Recommended time of battery replacement]
Thebatteryindicatorlightsgreenwhenthebatteryisfullycharged,
and turns into orange followed by red as the battery becomes
weaker. Subsequently, the battery indicator starts ashing red,
thensignaltransmissionwillbestoppedsoon.Whentheindicator
lightsred,replacethebatterieswithnewones.
The power indicator also ashes when the battery indicator is
ashingred.
Rough estimate of operating time on alkaline battery use
Batteryindicatorstatus Remainingbatterylife
Litgreen 2.5 – 5.5 hrs
Litorange 1 – 2.5 hrs
Litred 15min–1hr(Batteriesmustbereplaced.)
Flashingred 0−15min(Batterylifeisabouttoend.)
Notes
• Operatingtimevariesdependingontheconditionofusesuch
as ambient temperature.
• Theindicatorashesgreenifthemicrophoneissettoaninvalid
group/channelforwhichnousablefrequencyisassigned.
 (Seep.5.)
• Theindicatorashesorangewhenintestmode.(Seep.7.)
7. DIMENSIONAL DIAGRAM
Unit : mm