Instruction Manual

12.3. Output Unit Settings of the Packet Audio Signal

Packet audio signals can be transmitted not only to the PC but also to the TOA Network Audio Adapters NX-

100 and NX-100S via an Ethernet cable. In this case, it is possible to set which tuner unit's audio signals to be

output to the network.

12.3.1. Setting procedures

Step 1. Display "9 NETWORK" in the Operation menu display

Step 2. Press the Right key to go to NETWORK MENU.

Step 3. Press the Up and Down keys to go to MONITOR UNIT.

Step 4. Press the Right key to go to the tuner unit setting screen.

Step 5. Select the tuner unit to be output using the Up and Down keys

Step 6. Press the SET key.

Thesettingisconrmedandanasterisk

" " is displayed before the tuner unit on

the screen.

The mixing output of Unit 1 and Unit 2 as well as the individual outputs of Unit 1 and Unit 2 can be selected as

a Packet audio output.

Note

To use this function, network setting and the NX-100 or NX-100S settings must be performed in advance.

Settings can be made at the receiver in Local mode and from the PC in Remote mode.

M O N I T O R U N I T

[

U N I T 2 ]

12.4. IP Address check

Checksthereceiver’sIPAddress.

12.4.1. Setting procedures

Step 1. Display “9 NETWORK” in the Operation menu display.

Step 2. Press the Right key to go to NETWORK MENU.

Step 3. Select “IP ADDRESS” using the Up

and Down keys, then press the Right

key.

Receiver’sIPaddressisdisplayed.

12.5. MAC Address check

Checksthereceiver’sMACAddress(networkcarduniqueidentier).

12.5.1. Setting procedures

Step 1. Display “9 NETWORK” in the Operation menu display.

Step 2. Press the Right key to go to NETWORK MENU.

Step 3. Select “MAC ADDRESS” using the Up

and Down keys, then press the Right

key.

Receiver’sMACaddressisdisplayed.

I P A D D R E S S

1 0 . 1 5 4 . 2 3 . 9 5

M A C A D D R E S S

0 0 1 5 - 5 F 9 2 - A 0 9 5