Installation Instruction Manual

Page 6 – S5 Wireless Microphone Installation Guide Rev 1.5
1. Attach the 2 supplied antennae to
the rear panel BNC antenna
connectors as shown left.
2. Connect the AC/DC adaptor into
the DC inlet as marked on the rear
panel, feeding the cable through the attached strain relief. Observe that the
front panel on-off switch surround is illuminated red.
3. Connect the rear panel audio output from either the ¼” jack or XLR to your
mixing console or amplifier. Note: the XLR balanced output can be switched
for either mic or line. The system can be also monitored from the headphone
socket, using the “Jog-Wheel” to adjust the volume level.
4. Switch the On/Off switch to the “On” position. The switch surround will now
be illuminated green and the receiver will default to its initial setting (BK1.01).
The system is now ready for use.