Z 1 TOA pa INSTRUCTIONS UHF WIRELESS MICROPHONE WM-5320 WM-5320A WM-5320TH Thank you for purchasing TWA's UHF Wireless Microphone. Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment. TABLE OF CONTENTS ts « SAFETY PRECAUTIONS errs sessions ss sensuousness 2 2. GENERAL DESCRIPTION i FEATURES Essen assassinates semis eases sss domes svnsns 2 4. HANDLING PRECAUTIONS sss ss 3 5. NOMENCLATURE senses chess sass 3 6. BATTERY INSERTION sss 5 7.
1. SAFETY PRECAUTIONS + Be sure to read the instructions in this section carefully before use. » Make sure to observe the instructions in this manual as the conventions of safety symbols and messages regarded as very important precautions are included. = We also recommend you keep this instruction manual handy for future reference.
= Operates on a single AA battery. * Employs a built-in antenna. * The state of battery consumption can be displayed on the tuner's indicator when the unit is used in conjunction with the optional WT-8800, WT-5806 or WT-5810 Wireless Tuner. 4. HANDLING PRECAUTIONS = Do not expose the unit fo rain or an environment where it may be splashed by water or other liquids, as doing se may result in unit failure. » Never open nor remove the unit case to modify the unit.
[Microphone unit] (WM-5320 only) Unit. mm 130 cm in length “Plug lock 33.5 Conduct the microphone cable so that noise due to friction is avoided. [Headset] (WM-5320A only) [Headset] (WM-5320TH only) . Adjustable band . Goose neck Windscreen Plug lode Goose neck Windscreen Plug lock 0835 23.
6. BATTERY INSERTION Step 1. Tum off the power switch. Step 3. Insert an AA battery according to and indications on the battery compartment. Sep 2. Remove the battery cover from the unit. Slide the battery cover in the direction Step 4. Replace the removed battery cover. indicated by the arrow while pushing down the cover with a thumb as shown in the figure. Battery replacement « A brand-new AA alkaline battery will continuously operate the unit for about 10 hours.
8. OPERATION Step 1. Plug the microphones plug into the input connector as illustrated. Step 2. Confirm that the wireless microphone and the wireless tuner are identical in the channel number. If not identical, turn the power ON/OFF switch to the OFF position, then set the channel number to the samey channel number as the tuner. Step 3. Tum the Power ON/OFF switch to the ON position. Then, confirm the green LED of the Power/Battery lamps will light.
11. AUDIO LEVEL ADJUSTMENT (SENSITIVITY CONTROL) To change the factory-preset level, follow the procedures below. Step 1. Holding the microphone bad, open the rubber cap as illustrated. Step 2. Switch on the power of the tuner and microphone. Step 3. Adjust the audio level control using the supplied screwdriver. The microphone sensitivity increases as the control is rotated clockwise, and decreases as rotated counterclockwise. Step 4.
13. SPECIFICATIONS [WARSAW] Microphone Element Electric condenser type, omnibus-directional pattern Modulation Frequency modulation Frequency Range 692 ~ 865 MHz, UHF Electable Haring! 64 frequencies (the number of channels may differ from country to country.) RF Carrier Power Lees than 50 mw Tone Frequency 32.
