User's Manual

8.2. Performing Encryption Settings

To enhance security, the WM-D5300 is provided with an encryption setting function that prevents

leakage of transmitted information.

This function also has the advantage of eliminating radio interference if enabled. Before enabling

theencryptionsetting,besurethatbankandchannelsettingsarecompletedrst.

Note

In addition to the WM-D5300, the WT-D5800 Digital Wireless Receiver also requires setup.

Therefore, be sure to see the receiver's instruction manual as well.

8.2.1. Encryption settings summary

[Before use (preparatory operation for setting)]

Transmit an ID number from the wireless transmitter to the receiver. The ID number is randomly

selected on the wireless transmitter side. The ID number to be used is selected from an extensive

numberofcombinationsandcannotbedesignatedbytheoperator,norcanitbeidentiedfrom

outside.

[In use] (No operations required.)

When the receiver detects a signal from the wireless transmitter, it simultaneously reads the

transmitter's ID information, ensuring that only the audio of the wireless transmitter assigned with

the same ID number as the receiver can be output. Even if the bank/channel numbers are identically

set in an attempt to enable reception of a radio signal from outside, since no audio is output if the

ID number does not match, the possibility of leakage of transmitted information to the outside is

quite low.

[Encryption Setting ON/OFF Confirmation]

Step 1. After removing the battery cover, switch ON the transmitter power switch.

Step 2. ConrmthestatusoftheEncryptionindicator.

The setting is ON when the indicator is lit, and OFF when the indicator is unlit.

Note: The encryption setting is factory-preset to OFF.

Encryption indicator

Encryption setting

switch