Use and Care Manual

LINE CORD SAFETY TIPS

1. Never pull or yank on cord or the appliance.

2. To insert plug, grasp it rmly and guide it into outlet.

3. To disconnect appliance, grasp plug and remove it from outlet. Do not pull on the

line cord.

4. Before each use, inspect the line cord for cuts and/or abrasion marks. If any

are found, this indicates that the appliance should be serviced and the line cord

replaced.

5. Never wrap the cord tightly around the appliance, as this could place undo stress

on the cord where it enters the appliance and cause it to fray and break.

IMPORTANT

During the rst few minutes of initial use, you may notice smoke and/or a slight odor.

This is normal and should quickly disappear. It will not recur after appliance has been

used a few more times.

WARNING: To reduce the risk of re or electric shock, do not remove the bottom

cover. No user serviceable parts inside. Repair should be done by authorized

service personnel only.

UNPACKING:

1. Carefully unpack the Coffee Maker and all parts. Remove any tape, labels or

packaging materials.

2. Wash brew basket, glass carafe and carafe lid with warm, soapy water. Rinse well

and dry thoroughly.

3. Wipe exterior surfaces of the product with a soft, moist cloth to remove dust particles

collected during packing and handling. NEVER IMMERSE THE COFFEE MAKER,

CORD OR PLUG IN WATER OR ANY OTHER LIQUID.

4. Place Coffee Maker on a solid, level, heat-resistant surface.

PREPARING FOR USE

CLEANING THE COFFEE MAKER:

Before the rst use, the Coffee Maker should be rinsed with clean water by running a

brew cycle.

1. Fill the glass carafe to MAXIMUM FILL LINE with cool water and pour it into the

water reservoir.

2. Make sure the swing-out brew basket is properly closed.

NOTE: Allow water to cycle through without coffee, this will clean the

water reservoir and swing-out brew basket.

3. Plug the Coffee Maker into an electrical outlet. Ideally, the Coffee Maker should be

operated on its own circuit, separate from other appliances.

4. Push the ON / OFF button to the ON position. The red light in the switch will

illuminate and the brew cycle will begin. The brew cycle will take approximately 10

to 12 minutes to complete.

5. After the cycle is complete, push the ON / OFF button to the OFF position.

6. The Coffee Maker is now ready for use.