Instructions / Assembly

6
3.Install the rear wheel
2
1
Figure 1: Install rear axle and base on car body; fix with 8pcs M4*12mm screws.
Figure 2: Install drive motor on the rear axle. Load a wheel on the rear axle .Load a M10
gasket on the rear axle .Tighten 8 nuts with a plastic wrench .Add a plastic core cover.
4.Install the steering wheel
Butt connection plug[as shown].
Insert the steering wheel into
the end of the direction bar.
Alignment of the hole on the
steering wheel with the hole on
the direction bar and insertion
of the M5 x 35mm unit screw.
5.Install the windshield
1
2
Figure 1: Single side with 2pcs
M4*12mm screws to install the
reflector on the windshield.
Figure 2: Put the windshield on
the car body.
Dock the docking plug before
installing the seat
Note: power plugs cannot be
operated in reverse
6.Turn on the power plug
Both sides
of the rear
wheel
installation
method is
the same
X2