Instructions / Assembly

When charging, turn off the power switch.
After first use, recommend to charge 8 hours but not more than 12 hours.
When the vehicle speed slows down obviously, indicating the battery is low, please charge.
After use, please charge 8 to 12 hours, not exceeding 20 hours.
Charging exhibition
Troubleshooting
■ Problem: the vehicle can not move
Answer 1: it is low battery
Please charge in time after each use, charge at least once each month. Recommend to
charge 8 to 12 hours but not mor e than 20 hours.
Answer 2: overloading
An automatic reset fuse is equipped in the battery box. When overloading, it will cut off
the power for 15 to 20 seconds, then restart.
To avoid fuse cut off the power:
1.Max:30kgs, overload is forbidden.
2.Do not drag any items behind this products.
3.Do not allow water or other liquids dip the
electrical parts.
4.Do not change the line system by yourself.
Answer3: battery is broken
Please contact the agent or manufacturer.
Answer4:car body wiring has been damaged
Please contact the agent or manufacturer.
Answer5:the motor is damaged
Please contact the agent or manufacturer.
Installation instruction
1.Wheels installation
Install the tire with the front wheel axle till it is settled.Put the tire out , see if it is finally
settled At last, put the wheel cover onto the tire outside. (same method for all wheels)
2.Power connection
Connect the power terminal port with the
main line. red line connects with red line,
black line connects with black line.
(note: connect the pole in correct way)
3.Steering wheel installation
Connect the lines, insert the steering wheel
in the correct direction.Use finger to press
the two steel round balls,push the steering
wheel untill the ball locks in the two holes.
4. Windshield installation
Insert the windshield onto the car ,
settle it with the hole on the dashboard.
5. Rearview mirror installation
Insert the left mirror on the left door, insert
the right mirror on the right door.
6.Seat installation
Put the seat in 45°angle,insert the two hooks into
the two holes. Lock the seat with one screw on the
backside.(screw 4*14mm)