User's Manual

Ɣ Use the start menu in Windows (recommended when possible).
Should you be unable to shut the device down using the above, you can hold the power button on the top side of the device
down for more than ten (10) seconds. The device will consequently shut down immediately, without waiting for open applica-
tions to close.
This is not considered a "clean" Windows shut down and is thus not recommended unless completely necessary be-
cause it can harm you device.
5.3 Power Saving
The Power saving settings in the Tobii Dynavox I-Series device are preset to optimize the battery run-time. If needed, the time
setting for sleep mode can be adjusted in Windows Power Options.
5.3.1 Turn Off/On the Screen
Turn Off Screen
Ɣ A single press of the power button will turn off the screen and the device will be idle.
Turn On Screen
Ɣ A single press of the power button and you should be back where you left off.
Ɣ Alternatively you can long hold the home button to wake up the device.
5.4 Using the Cameras
The two built-in cameras allows you to take snapshots of items facing the backside of the Tobii Dynavox I-Series device and al-
so from the display side.
Use Tobii Dynavox Communication Software or other relevant software to operate the cameras.
5.5 Adjusting the Volume
To adjust the volume use the Volume Up and Down buttons (Position 2) on top side of the Tobii Dynavox I-Series device. For
position references, see Figure 3.1 Tobii Dynavox I-Series Tablet, page 13
Volume adjustments can also be done in Tobii Dynavox Communication Software and in Windows.
5.6 Adjusting the Sound
You can configure the speakers using the Windows 10 Control Panel > Sound.
We refer to Microsoft’s information on how to configure the sound in the Windows 10 Control Panel.
Sound adjustments can also be done in Tobii Dynavox Communication Software.
Tobii Dynavox I-Series User’s manual v.1.0 - en-US
5 Using the Tobii Dynavox I-Series
17