Installation Guide
8ft-to-4ft Retrot Kit Installation Instructions (English)
MODEL: FC8TO4
Included:
Installation Instructions
Lampholder Bracket Assembly
Wire nuts (x2)
Self-tapping screws #8 X 1/2” (x8)
Important Information - Read before beginning installation:
Warning - Risk of re or electric shock. Luminaire wiring and electrical parts may be damaged when drilling for installation of LED retrot kit. Check
for enclosed wiring and components.
Warning - Risk of re or electric shock. LED Retrot Kit installation requires knowledge of luminaires electrical systems. If not qualied, do not
attempt installation. Contact a qualied a electrician.
Warning - Risk of re or electric shock. Install this kit only in the luminaires that have the construction features and dimensions shown in the
photographs and/or drawings and where the input rating of the retrot kit does not exceed the input rating of the luminaire.
Warning - To prevent wire abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
Warning - This xture must be grounded and installed in accordance with all national and local electrical codes, by a person familiar with the
construction and operation of the product and the hazards involved.
Warning - The combined wattage of the replacement Type-B LED tubes shall not exceed the rated wattage of the intended luminaire.
Only those open holes indicated in the photographs and/or drawings may be made or altered as a result of kit installation. Do not leave any other
open holes in an enclosure of wiring or electrical components.
This device is not intended for use with emergency exits.
This retrot process does not change the environmental rating of the xture being retrotted. For damp location placements, the xture needs to
be rated as such.
This kit is intended for indoor use or weather protected xtures only. Do not use where directly exposed to water or water spray.
This retrot kit is accepted as a component of a luminaire where the suitability of the combination shall be determined by authorities having
jurisdiction.
1.844.864.4533 support@toggled.com See toggled.com/warranty for details.
11-02013-AA 2020-11-10
Installation
1. Turn off power to the uorescent xture at the circuit breaker.
IMPORTANT - Installation of this retrot kit requires modication of the wiring within the existing uorescent xture. Please read the
entire installation instructions before beginning your installation.
Please examine all parts that are not intended to be replaced by the retrot kit for damage and replace any damaged parts prior to
installation of the retrot kit.
2. Remove existing uorescent tubes.
4. Disconnect and remove uorescent ballast(s), lampholders, and lampholder brackets.
BALLAST
BLACK
WHITE
AC LINE
96” FLUORESCENT LAMP
96” FLUORESCENT LAMP
BLACK
WHITE
AC LINE
TOGGLED DIRECT-WIRE LED TUBE
TOGGLED DIRECT-WIRE LED TUBE
TOGGLED DIRECT-WIRE LED TUBE
TOGGLED DIRECT-WIRE LED TUBE
BEFORE RETROFIT:
AFTER RETROFIT:
POWERED END OF LAMPS MUST FACE CENTER OF FIXTURE.
3. Remove housing covers by rst twisting and pulling retainer clips. Set all aside for
reinstallation later.
5. Separate new bracket assembly into 3 pieces.
Assembly may be separated by bending the brackets at the connecting points back and forth until they detach.
IMPORTANT: This retrot kit is only suitable for xtures with
widths of 4.25” or 5”. Please verify this dimension in the drawing
shown.
The xture must also have (2) 4ft housing covers. If the xture has
(1) 8ft housing cover, do not use this kit as you will not be able to
enclose the wiring compartment.
Sold Separately:
UL recognized Type-B LED Tubes (Single-ended Power)
Required Tools:
Wire cutters/strippers
Drill/impact driver
1/4” Hex-drive bit
1/8” drill bit (optional)