Specification Sheet

1
ULTIMATE TENSILE PULL-OUT VALUES
[lb]
Anchor UNC thread Drill dia.
1/2"
Drywall
5/8"
Drywall
*1/2" with 25
gauge stud
*5/8" with 25
gauge stud
Concrete
block
1/2" steel
plate
Stainless in
1/2" steel
3
BA
3/16"-24
1/2" 238 356 412 462 802 918
1
1,193
1
BB
1/4"-20
1/2" 265 356 425 464 1,080 1,288
2
1,735
1
BE
5/16"-18
3/4" 270 480 439 477 1,400 1,680 2,118
BC
3/8"-16
3/4" 275 576 466 488 1,745 1,692 2,523
1
BD
1/2"-13
3/4" 275 576 468 513 **2,038
2
2,605 3,150
• Industry standards recommend 1/4 of ultimate test load.
• Holding strength for a SNAPTOGGLE heavy-duty hollow-wall anchor varies directly with the strength and condition of the substrate
and the bolt size—and inversely with variations in hole diameter and the distance of the load from the wall.
• All figures in pounds. Pull-out values based on independent laboratory tests done according to U.S. Government standards.
They should be used as guides only and cannot be guaranteed. The age, condition, and capacity of the substrate must
be considered.
* Failure measured as breakage of drywall portion
** Failure of block
1
Stainless steel bolts used
2
Hardened bolts used
3
Stainless steel channel tested with stainless bolts in 1/2" steel plate
The latest generation of the ever-evolving
TOGGLER hollow-wall anchor technology...
• Holds up to 2x the load
• Solid metal channel resists vibration & shock
• Pre-assembled and ready for immediate use
• Pre-installs without fixture or bolt
• Installs in a significantly smaller hole
• Automatically adjusts to thickness of wall, ceiling, or floor
• Does NOT spin—bolt installs with a screw gun
• Uses a shorter bolt—no need to carry a wing
• New plating is 7 times more corrosion-resistant
• Does NOT fall behind wall when bolt is removed; fixture
can be removed and reinstalled as often as desired
The SNAPTOGGLE anchor is a heavy-duty hollow-
wall anchor for use in walls, ceilings, or floors of
materials such as gypsum board, drywall with a
steel stud, concrete block, tile over drywall, etc.
The anchor is pre-assembled and ready for immediate
use. The ratcheting strap / locking cap assembly
positions the one-piece zinc-plated (or stainless)
steel anchoring channel flush against the rear of
the wall. The cap slides down the straps to lock
flush against the front of the wall. The straps on
the outside of the wall are then easily and quickly
snapped off by hand flush with the surface of the
wall (no extra tools required). Holding is dependent
only on a metal bolt to metal channel connection.
The SNAPTOGGLE anchor complies with all
existing fire codes for critical applications.
SNAPTOGGLE
®
HEAVY
-DUTY HOLLOW-WALL ANCHORS
ANCHOR SYSTEM
Technical Bulletin
ULTIMATE SHEAR
[lb]
Anchor UNC thread Drill dia.
1/2"
Drywall
5/8"
Drywall
BA
3/16"-24
1/2" 247 298
BB
1/4"-20
1/2" 241 324
BC
3/8"-16
3/4" 292 406
Benefits compared to wing toggles: