Information Sheet

ManualsBrandsToggler ManualsAnchorsLag Screw Shield (1/2 x 3" / Box of 25)

Lag Screw Shields

1-203-857-2200 • www.wejit.com Page 1 of 4

Key Features & Benets

 Corrosion resistant – made of a zamac alloy

 Suitable for concrete, masonry and masonry joints

 Longer lengths add joint strength in softer materials

 Internally threaded anchor allows easy bolt removability

and service work

Specications, Listings

and Approvals

Anchor Thread Diameters: 1/4" - 5/8"

Material: Zamac Alloy

Federal Specications: GSA FFS-

325C, Group 2, Type 1, Class 1 (long),

Class 2C (short)

Description

The Lag Screw Shield is a corrosion resistant anchor designed

to be used with lag screws in concrete and the mortar joints

of brick and block walls. For soft or weak masonry, the long

version is recommended to add strength to the substrate. The

short version is recommended for harder masonry materials

to reduce drilling time.

Applications

 Railings

 Removable Applications

 Soft and Hard Work

Surfaces

 Outdoor Applications

ENGINEERED

Long

Short

Summary of content (4 pages)

PAGE 1
Lag Screw Shields Description The Lag Screw Shield is a corrosion resistant anchor designed to be used with lag screws in concrete and the mortar joints of brick and block walls. For soft or weak masonry, the long version is recommended to add strength to the substrate. The short version is recommended for harder masonry materials to reduce drilling time.
PAGE 2
Lag Screw Shields Installation Information Instructions 1. Drill the hole perpendicular to the work surface. To assure full holding power, do not ream the hole or allow the drill to wobble. Drill the hole at least one anchor diameter deeper than the intended embedment, but not closer than two diameters to the bottom (opposite) surface of the concrete. 2. Clean the hole with a nylon brush and compressed air. 1 2 3 4 3. Insert anchor into the hole and tap flush. 4.
PAGE 3
Lag Screw Shields Performance Data Long Ultimate and Allowable Load (lbs.) – Normal-Weight Concrete Anchor Thread Dia. (in.) 1/4 Long 5/16 Long 3/8 Long 1/2 Long 5/8 Long Allowable Ultimate Min. Embed. 2,000 psi 4,000 psi 6,000 psi 2,000 psi 4,000 psi 6,000 psi Depth (in.
PAGE 4
Lag Screw Shields Order Information Short Lag Screw Shields: Zamac Alloy Catalog No. Drill Bit Dia. (in.) Lag Bolt Size Anchor Length (in.) LSS14 LSS56 LSS38 LSS12 LSS58 1/2 1/2 5/8 3/4 7/8 1/4 - 10 5/16 - 9 3/8 - 7 1/2 - 6 5/8 - 5 1 1-1/4 1-3/4 2 2 Box Carton Quantity Quantity 50 50 50 25 25 1000 1000 500 250 250 Long Lag Screw Shields: Zamac Alloy Catalog No. Drill Bit Dia. (in.) Lag Bolt Size Anchor Length (in.