User Manual

ManualsBrandsTOHNICHI MFG ManualsElectronicsRF module

User Manual

TOHNICHI RF MODULE

MODEL: FMAM

The purpose of this manual is to explain correct way how to integrate module FMAM to

the end product. It includes procedures that shall assist you to avoid unforeseen

problems. This manual presents information that shows how module and end product,

where module integrated, complies with regulations in certain regions. Any modifications,

not expressly approved by the manufacturer could void the authority to operate in these

regions.

The TOHNICHI RF MODULE, model FMAM is installed in a portable device or in a fixed

device. The usage is only for data transmission.

And the FMAM RF MODULE has to be installed and used in accordance with the technical

description/installation instructions provided by the manufacturer.

The RF module is allowed to be used with internal chip antenna or with Dipole antenna

used during test. The antenna gain of both antennas is 0dBi. When the antenna with

higher antenna gain than 0dBi or a different type of antenna is used with this RF module,

a submission of a permissive change application or a new application is required.

For detail information concerning type approval of this module (e.g. where this module is

already pre-approved) please contact the authorized local distributor or the

manufacturer.

The system may only be implemented in the configuration that was authorized. Note that

any changes or modifications to this equipment not expressly approved by the

manufacturer could void the user’s authority to operate this equipment.

Summary of content (5 pages)

PAGE 1
User Manual TOHNICHI RF MODULE MODEL: FMAM The purpose of this manual is to explain correct way how to integrate module FMAM to the end product. It includes procedures that shall assist you to avoid unforeseen problems. This manual presents information that shows how module and end product, where module integrated, complies with regulations in certain regions. Any modifications, not expressly approved by the manufacturer could void the authority to operate in these regions.
PAGE 2
Regulatory Information USA-Federal Communications Commission (FCC) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications.
PAGE 3
Caution: Exposure to Radio Frequency Radiation. To comply with FCC RF exposure compliance requirements, this device must not be co-located or operating in conjunction with any other antenna or transmitter.
PAGE 4
Canada-Industry Canada (IC) This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of this device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
PAGE 5
Instructions to OEM Integrators A User manual provided to the end user must indicate the operating requirements and conditions that must be observed to ensure compliance with the above-mentioned FCC /IC RF Exposure guideline. If this module is intended for use in a portable device, integrators are responsible for separate evaluation and/or approval to satisfy FCC/IC RF Exposure requirements.