User's Manual

User Manual

TOHNICHI RF MODULE

MODEL: M-FH

The purpose of this manual is to explain the correct way to integrate

module M-FH to the end product. It Includes procedures that shall assist

you to avoid unforeseen problems. This manual presents information that

shows how module and end product, where module integrated, complies

with regulations in certain regions. Any modifications, not expressly

approved by the manufacturer could void the authority to operate in these

regions.

TOHNICHI RF MODULE, model M-FH is installed in a receiver. The usage

is for data transmission / reception.

And the M-FH has to be installed and used in accordance with the technical

description / installation instructions provided by the manufacturer.

The system can only be implemented in approved configurations. Note

that any changes or modifications to this equipment not expressly

approved by the manufacturer could void the user’s authority to operate

this equipment.

The antenna used for this transmitter must be installed to provide a

separation distance of at least 20 cm from all persons and must not be

co-located or operating in conjunction with any other antenna or

transmitter.

PAGE 1
User Manual TOHNICHI RF MODULE MODEL: M-FH The purpose of this manual is to explain the correct way to integrate module M-FH to the end product. It Includes procedures that shall assist you to avoid unforeseen problems. This manual presents information that shows how module and end product, where module integrated, complies with regulations in certain regions. Any modifications, not expressly approved by the manufacturer could void the authority to operate in these regions.
PAGE 2
Regulatory Information USA-Federal Communications Commission (FCC) This device complies with Part 15 of the FCC Rules. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 3
Canada-Industry Canada (IC) This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: 1.This device may not cause interference. 2.This device must accept any interference, including interference that may cause undesired operation of the device.