User's Manual

4. Battery Check

Set the switch of the Battery Checker FM-BCY (Option) to BC side.

Insert the plug of the Battery Checker to the battery terminal of the

Transmitter. The battery should be serviceable if within “OK” range.

If the indicator shows the yellow range, replace the battery. If the

indicator shows “NG”, replace the battery. Refer to 8-2 Replacing the

Transmitter Battery when replace the battery.

5. Channel Setting

Turn off the receiver. To change the current channel, change the position of the

dip switches on the board of the Transmitter and the Receiver. (Refer to the

Table 3〜5.) Channel indication is as follows.

Transmitter：F-FM96MCUA1

-16

Receiver：R-FM96DA1

-16

Ex. 1：Change of the Transmitter Channel (only tone frequency)

(1) Remove the Transmitter cover.

(2) Change the position of the DIP switches, referring to the Table 3.

(3) Put the transmitter back.

Ex. 2：Change of the Receiver Channel

(1) Remove the front cover.

(2) Change the position of the DIP switches located upper part of the Transmitter

for the radio frequency, referring to the table4. (6 DIP switches)

(3) Change the position of the DIP switch SW 2 located lower part of the

Transmitter for the tone frequency, referring to the table 5. (4 DIP switches)

(4) Put the front cover back.

Channel number of tone frequency

(1〜16ch)

Channel number of radio frequency

(A1toA6 or B1toB6)

Channel number of tone frequency

(1〜16ch)

Channel number of radio frequency

(A1toA6 or B1toB6)