User's Manual

LED

4 Set Antenna Connector

Set AAA battery in the cell, and fit the outer cover with two screws.

Tightening Torque : 270cN.m

Note : FM stud must be located as below drawing shown.

OK NG

5 Check of Operation

Check to make sure that the Light Emitting Diode turns on when the toggle

is depressed and it makes a “click “sound, then perform the following tests.

A. Twist the torque wrench right and left in a no load state to make sure the LED

does not light up.

B. Twist the torque wrench right and left in the state in which the goggle

is the LED should remain ON.

6 Final Check

Perform test to check whether or not the receiver unit, R-FM96D receives

the FM transmission when a bolt is tightened and wrench clicks.

Stud is wrongly stayed between

plate spring and Battery case

Stud