User Manual
6-6 Channel, Group and ID Setting
6-6-1 RF Transceiver Setting
① Set the Setting Selector Switch on the RF Transceiver to “Left” side. The Operation
Check LED turns red and is flashing.
② Push the GET Switch on the RF Setting Box. The current setting appears on the upper
display.
③ Set up a channel group, a criterion code and ID (3 digits).
④ Push the SET Switch on the RF Setting Box.
⑤ The Operation Check LED turns green and lights up around 1 second. After that, it turns
red and starts to flash.
⑥ After confirmed the setting, set the Setting Selector Switch to “Right” side.
6-6-2 RF Terminal Setting
① Set the Setting Selector Switch on the RF Terminal to “Left” side. The SIGNAL LED is
flashing.
② Push the GET Switch on the RF Setting Box. The current setting appears on the upper
display.
③ Set up a channel group, a criterion code and ID (3 digits).
④ Push the SET Switch on the RF Setting Box.
⑤ The buzzer of the RF Terminal starts if the buzzer ON/OFF switch is set to ON.
⑥ After confirmed the setting, set the Setting Selector Switch to “Right” side.