Instruction Manual

5
2.3 Setting a data length
2.4 Setting a stop bit length
2.5 Setting a parity
2.6 Setting whether to conduct a BCC check
Operate the ▲ and ▼ keys to make the settings. The initial value is HHHH.
˜¿¢p
p: Stop bit length
F
Stop bit 1
I
Stop bit 2
¢: Parity
c
No parity
f
Odd parity
D
Even parity
¿: Data length
N
Data len
gth, 7 bits
E
Data length, 8 bits
˜
:
BCC check
c
BCC check disabled
j
BCC check enabled
2.7 Setting a communications speed
Operate the ▲ and ▼ keys to make the settings. The initial value is HH.
＊＊＊＊
I
12
00 BPS
K
2400 BPS
E
4800 BPS
M
9600 BPS
2.8 Setting an address
Operate the ▲ and ▼ keys to make the settings. The initial value is H.
Setting range: 1 to 99 stations (It cannot be set to a 0.)
2.9 Setting a response delay time
Set a time from the time when the high-level computer finished sending a "request message" until
the time when it delivers the line and enters an input state.
Operate the ▲ and ▼ keys to make the settings. The initial value is ###.
Setting range: 0 to 250msec
* If the response delay time is set to a short setting, the communications may not be conducted
normally.
* In a real operation, the processing time for this product will be added, in addition to the response
delay time.