User Manual

48-7009-E 7-18
7.5.5 Control setting mode (SET 04) (3/4)
Setting data
Character
Setting (monitor) value
Initial value
Unit
Setting
value
Blind
Primary control
operating amount
change limiter ascent
oU1
0.0 to 549.9
0.0
%
Primary control
operating amount
change limiter
descent
od1
0.0 to 549.9
0.0
%
Primary control
soft-start output
SFM
MLL1 to MLH1
100.0
%
Primary control
soft-start time
SFT
00:00 to 499:59
Function turned off with 00:00
(second) setting
000:00
Second
Primary control
at-abnormality
operating amount
FAL1
Digital output: 0.0 to 100.0
Analog output: -10.0 to 110.0
0.0
%
Primary control loop
anomaly PV threshold
tS1
Temperature: 0.0 to 999.9
0 to 999
Analog: 0 to 9999
0
C
Digit
Primary control loop
anomaly MV
threshold
MS1
MLL1 to LH1
100.0
%
Primary control loop
anomaly PV change
threshold
PS1
Temperature: 0.0 to 999.9
0 to 999
Analog: 0 to 9999
0
C
Digit
Primary control loop
abnormality time
LoP1
0 to 9999
0
Second
Primary control
off-point position
selection
CMod
0: SV unit setting
1: Upper
2: Middle
3: Lower
0
None
Primary control
sensitivity setting
C1
Temperature: 0.0 to 999.9
0 to 999
Analog: 0 to 9999
1
Digit
Primary control
off-point position
CP1
Temperature: -999.9 to 999.9
-999 to 999
Analog: -9999 to 9999
0
C
Digit
Primary control
protection off timer
Fdt1
0 to 99
0
Minute
Primary control
protection on timer
Ndt1
0 to 99
0
Minute
Secondary control
operating amount
MV2
MLL2 to MLH2
0.0
%
Secondary control
output gain
MV2G
0.0 to 100.0
100.0
%
Secondary control
proportional band
P2
0.10 to 10.0
1.00
Times
Secondary control
proportional cycle
t2
0.1 to 120.0
20.0
Second
Secondary control
operating amount
limiter upper limit
MLH2
Digital output: MLL2 to 100.0
Analog output: MLL2 to 110.0
100.0
%
Secondary control
operating amount
limiter lower limit
MLL2
Digital output: 0.0 to MLH2
Analog output: -10.0 to MLH2
0.0
%
Secondary control
operating amount
change limiter ascent
oU2
0.0 to 549.9
0.0
%
Secondary control
operating amount
change limiter
descent
od2
0.0 to 549.9
0.0
%
Note (Ndt1) is selectable only on Ver3.xx or later.