User's Manual

TMW1059
Rev.001 Page 17 of 17
10. Select the Authentication tab.
11. Enter the remaining 802.1x configuration as required by the particular authentication
services on the network.
12. Click OK to close the Authentication panel and go back to the WZCS profile
management panel.
If the newly configured network is not at the top of the Preferred Networks list, then press
the Move Up button until it is. Then click OK to close the panel.
13. Repeat the above procedures for the AP-Static network, but disable the settings
related to 802.1x.
14. Click OK to close the WZCS panel.
15. Configure the AP-LEAP network with a completely separate Client Utility profile. To
use this network, select that profile as well as disable WZCS as previously
discussed.
WZCS connects to the active network listed in the highest position in the Preferred Networks
list. For both the AP-Static and the AP-802.1x networks, the Client Utility-provided static
keys are installed. In the AP-Static network, these provide the required keys. In the
AP-802.1x network, they are installed and serve only to initialize the security data structures.
After association, the 802.1x key distribution protocol provides the real key material.