Installation Manual

NO.4、NO.5 (120°)
106 208 233
17 28
NO.2、NO.3 (155°)
66 162 165
17 22
NO.4、NO.5 (155°)
66 208 193
17 28
NO.2、NO.3 (120°)
116 162 215
17 22
TYPE A B C D E
7M2
7M2
7M27M2
INSTALLATION INSTRUCTIONS FOR DOOR CLOSER
STRONGER
CLOSING FORCE
Closing force can be
changed by turning
link shoe 180°before
installation.
The longer distance
from link to hinge
center line will make
closing force weaker.
The shorter distance
will make closing force
stronger.
HINGE CENTER LINE
WEAKER CLOSING
FORCE
2. CHECK DOOR HANDLING
1. DIMENSION CHART
4. MARK ON THE DOOR AND TOP JAMB
6. ADJUST SPEED
3. ADJUST CLOSING FORCE
5. DRILL HOLES
Standard type door closer application
Place template along
door edge. Use a
hammer and punch to
mark the center of
each screw hole then
remove template.
Adjust closing speed by turning
1st screw. Adjust latch speed
by turning 2nd screw.
Turn screw clockwisely to
reduce speed.
HAMMER
PUNCH
ADHESIVE TAPE
TOP JAMB
DOOR
ELECTRIC
DRILL
WOOD SCREW
(FOR WOODEN
DOOR)
MACHINE SCREW
(FOR ALUMINUM OR
STEEL DOOR)
FAST SLOW
LATCH SPEED
TEMPLATE
For wooden doors,
drill pilot holes #14
(diameter 5mm) on
door and frame for
wood screws. For
metal doors, drill
and tap holes
1/4"-20 (M6) for
machine screws.
1
2
2ND SCREW
LATCH SPEED
1ST SCREW
CLOSING SPEED
CLOSING SPEED
(RIGHT HAND DOOR)(LEFT HAND DOOR)
DOOR
HINGE
EXTERIOR
INTERIOR
CLOSING SPEED
REGULATING
SCREW
This door closer can be applied to both right hand(RH)
and left hand(LH) door opening.
Before installation, check door handling by referring
to illustration shown above.
HINGE CENTER LINE
DE
19
44
B
C
A
1
2
HINGE
PINION CAP
BODY
MAIN ARM
LINK SHOE
SPEED REGULATING
SCREW
LINK