TG7000 Operations Manual

ASSEMBLY

Install the mounting foot to the frame using M8

flange bolts and nuts.

6. Install the handles using the clevis pin and hairpin

cotter as shown in Figure 7.

Figure 5 – Assemble Mounting Foot to Frame

1 - Rubber Pads 3 - M8 Flange Bolt Figure 7 – Attaching the Handles

2 - Mounting Foot

and Nut

1 - Clevis Pin 3 - Hairpin Cotter

Install the 16 mm x 105 mm axle pin through the

axle bracket on the frame.

Install the hairpin cotter through the axle pin.

2 - Handle 4 - Negative Battery

Cable

Figure 6 – Assemble Wheels to Frame

1 - Axle Pin 2 - Hairpin Cotter