Instruction Manual

2-2.TOMEI TITANIUM MUFFLER TYPE-60S INSTALLATION

【Illustration of the mounting position of each parts】

The installation of the included parts in the kit is shown below.

When installing TYPE-60R/60S, the stock gaskets & springs are to be reused.

① MAIN PIPE A ⑦ SILENCER BAND

② MAIN PIPE B ⑧ SILENCER BAND RUBBER

③ TYPE-60S SILENCER ⑨ FLANGE BOLT M8 L=25mm　　　　

④ TYPE-60S TAIL PIPE ⑩ FLANGE NUT M8 【 20.0～28.0 N・m (2.0～2.9 kgf-m) 】

⑤ CLAMP BAND 【 16.0 N.m (1.63 kgf-m) 】 ⑪ SOUND REDUCER

⑥ SPRING ⑫ BUTTON BOLT M6 【 8.0～12.0 N・m (0.8～1.2 kgf-m) 】

* Apply the bolt smooth paste that is supplied in the kit to

prevent metal burns and seizures to the bolts and nuts.

【INSTALLATION PROCEDURE】

Use the stock bolts and nuts for fitting the Main pipe A to the catalytic converter.

Install the pipe with the stopper facing up.

2. Fit the clamp band on the Main Pipe B, then keep the pipes parallel to each other so the springs

hooks will be aligned with each other. Do this before inserting the main pipe B to the Main Pipe A.

Then you fit the muffler hanger as well.

※Use the supplied Clamp Band (Ref ⑤).

Fit the clamp band on the Silencer, then keep the pipes parallel with each other to align the spring

hooks. Do this before inserting the Silencer to Main Pipe B. Then fit the hanger as well.

※Use the supplied Clamp Band (Ref ⑤).

The mufflers Tomei Logo is to be installed facing down to the ground.

4. Place the Silencer Rubber onto the Silencer Band, and carefully install on the Silencer body.

Then install onto the exhaust hanger. Contact with rough surfaces may damage the Silencer.

* Use the supplied Silencer Band (Ref ⑦) & Silencer Band Rubber (Ref ⑧)

Flange Bolt M8 (Ref ⑨) Flange Nut M8 (Ref ⑩).

5. Fit the clamp band on the Tail Pipe, then insert the Tail Pipe to the Silencer.

Then fit the muffler hanger to complete it.

※ Use the supplied clamp band (Ref ⑤).

①

②

③

< Kit Contents Torque Specs >

⑥

⑦

⑨

⑤

④

⑪

⑫

⑩

⑧

⑤

⑥