User guide

INSTALLATION VERIFICATION

1. Check again the vehicle that there are no parts interfering with any other components.

2. Start the engine and let it idle first before taking it up to 2500 RPM to check and listen for any

signs of exhaust leaks or any abnormal sounds. Then recheck the car again for any loose parts

or gas leaks.

3. After the initial test drive check the car again for any signs of exhaust gas leakage and any

loose parts, bolts and nuts.

WARNING

· Any interference with any parts/components can pose a fire risk hazard so please meticulously

check the car after the install.

· Any exhaust leaks can decrease performance efficiency and also pose a health risk hazard with

toxic exhaust gas poisoning.

· If there is anything felt abnormal when driving please stop immediately and check the car over.

· When any work or checks are to be done with the metal exhaust components then please do so

when it is cold to prevent any burns and injuries.

· If any parts are lost or have fallen off then does not restart the car until the missing parts) can be

replaced properly.

CAUTION

・The vehicles characteristics may change after installing this product so after the install

you may need to have the ECU map settings checked and adjust accordingly to suit

the new setup.