Instructions / Assembly

1 OF 2

SLIDEMOOR FLOATING DOCK BRACKET ASSEMBLY & INSTALLATION

INSTRUCTIONS

READ ALL INSTRUCTIONS AND NOTES BEFORE BEGINNING

ADDITIONAL MATERIALS NEEDED

• Enough bolts to properly secure track for your floating dock size and weight.

o Drilled for 2 bolts every 2 feet.

! If lag bolting, ½” x 4” stainless steel bolts minimum recommended in every hole.

• Enough bolts to properly secure floating dock bracket to dock.

o Use bolts as necessary to properly secure slide to dock per your application.

! (6) 5/8” holes provided on the dock bracket.

• Safety Rope for Track installation. Needs to fit ½” hole.

PLACEMENT OF TRACK

Middle of track should be located at the height of your floating dock when in the middle of the average

tide for your area.

If LOWEST position of your floating dock is known, place the BOTTOM of the track 12” lower than that.

TRACK INSTALLATION

1. Determine pilings to be used for your SlideMoor Floating Dock Bracket.

2. Tie safety rope through top hole and secure to dock. (In the event track falls into the water.)

3. Install ½" x 1" slide stop bolt in lower track hole and secure with lockwasher and nut. (Provided)

4. Position track within proper operating range (see NOTES above). Don’t remove backing tape on Track.

5. Mark top hole for drilling and remove track.

6. Drill top hole into piling.

7. Using top hole only, bolt track just snug back in place. Ensure track is plumb, centered, and straight.

8. Mark all of holes for drilling and remove track.

9. Drill all of the holes in piling.

10. Attach track using proper lag bolts or through bolts and nuts. Recheck and tighten after 1 week of use.

PAGE 1
SLIDEMOOR FLOATING DOCK BRACKET ASSEMBLY & INSTALLATION INSTRUCTIONS READ ALL INSTRUCTIONS AND NOTES BEFORE BEGINNING ADDITIONAL MATERIALS NEEDED • Enough bolts to properly secure track for your floating dock size and weight. o Drilled for 2 bolts every 2 feet. § • Enough bolts to properly secure floating dock bracket to dock. o Use bolts as necessary to properly secure slide to dock per your application. § • If lag bolting, ½” x 4” stainless steel bolts minimum recommended in every hole.
PAGE 2
SLIDE ASSEMBLY Slide comes assembled except for bolts for Floating Dock Bracket 1. Insert 3/8" socket head bolts through the bracket into the slide. 2. Secure with nylock nut and tighten. Repeat on other side. 3. Decide whether mounting on face or top of floating dock. 4. Assemble dock bracket to the slide bracket using ½” bolt with washers and nylock nut. (Provided) -When snugging the bolt, allow for 1/8” clearance to allow for rocking. 5. Lift slide assembly to top of track and slide onto track. 6.