Instructions / Assembly

9
Flip the frame over to install the remainder of the fasteners into the frame. Where indicated install
Stainless Steel Hex Head Bolt and Stainless Steel Nylon Locknut. Use the 5/16” Driver Bit to fully
tighten the Stainless Steel Hex Head Bolt while holding in place the Stainless Steel Nylon
Locknut with a 3/8” Box End Wrench.
NOTE: When assembling the frame components, if you encounter holes that do not line up exactly, it
is acceptable to use a drill to ream out the holes slightly for the fasteners to fit appropriately.
20x 20x
Hex
Bit
5/16” Driver Bit
3/8” Box
End Wrench
Stainless Steel
Hex Head Bolt
Stainless Steel
Hex Head Bolt
Stainless Steel
Hex Head Bolt
Stainless Steel
Nylon Locknut