User's Manual

15
6. Speed panel. This panel shows the following information:
 The speed limit at your location.
 Your current speed. If you drive more than 5 km/h or 3 mph over the speed limit the speed
panel turns red. If you drive less than 5 km/h or 3 mph over the speed limit the speed panel
turns orange.
 The name of the street you are driving on.
7. Current location. This symbol shows your current location. Select the symbol or the speed panel to
open the quick menu.
Note: If your START/VIA cannot find your location using GPS or other methods, the symbol
appears grey.
8. Route bar. The route bar is shown when you have planned a route.
Important: To see a wider route bar showing additional route information, change the setting for
Route Information.
The route bar
The route bar is shown when you have planned a route. It has an arrival information panel at the top,
and a bar with symbols underneath.
Important: To see a wider route bar showing additional route information, change the setting for
Route Information.
Note: The distance ahead shown by the route bar depends on the overall length of your route.
The arrival information panel shows the following information:
 The estimated time that you will arrive at your destination.
 The length of time to drive to the destination from your current
location.
 A parking button is shown near the destination flag when parking is
available near your destination.
Tip: If your destination is in a different time zone, you see a plus (+)
or a minus (-) sign and the time difference in hours and half hours in
the arrival information panel. The estimated time of arrival is the
local time at your destination.
If you have stops on your route, select this panel to change between
information about the next stop and your final destination.
You can choose the information you see on the arrival information panel.
The bar uses symbols to show the following information:
 The next two stops on your route.
 Petrol stations that are directly on your route.
 RDS-TMC Traffic.
 TomTom Speed Cameras and Danger Zones.
 Rest stops directly on your route.
You can choose the information you see on your route.
The symbols are in the order that they occur on your route. For traffic
incidents, the symbol for each incident alternates between showing the
type of incident and the delay in minutes. Select a symbol to see more
information about a stop, an incident or a speed camera. If a symbol is
shown on top of another symbol, selecting the symbols zooms in on the
route bar to show each symbol separately. You can then select a symbol.
The total time delay due to traffic jams and other incidents on your route,