User's Manual

Using the optional remote control
The remote control can be used to start and stop recording, and to manually tag your video. Use the
remote control when you can't easily or safely reach your camera.
You can hold the remote control in your hand, or you can attach it to a place you can easily reach.
Note : The remote uses Bluetooth Smart to connect to your camera and can only be used with one
camera at a time.
Connecting the remote control
1. From the Camera Status screen on your camera, move down to open the SETTINGS screen.
2. Select GENERAL , then move right.
3. Select CONNECT , then move right.
4. Select REMOTE , then move right.
5. Move up or down to turn it on.
Note : When connecting the camera to the remote control for the first time, any button press on the
remote control tells the camera that the remote control is out there and ready for connection.
Tip : The Viewfinder of the Mobile App also has remote control features – see MOBILE APP.
The remote control can control up to 50 cameras simultaneously from up to 180m in optimal
conditions. It has a small LCD screen which mirrors what is shown on the Camera Status screen.
The remote control can only be used with one camera at a time. If you want to connect your remote
control to a different camera, repeat the instructions above with the remote control in range of the
new camera.
Note : To change settings on the camera using the remote control, the camera needs to be in Wi-Fi
mode.
Changing the battery in the remote control ***THIS SECTION WAS MADE UP BY CLAIRE!!!***
The remote control uses a button cell CR2032 battery.
To change the battery do the following:
1. Using a small flat-head screwdriver, gently lever the back off the remote control.
2. Gently lever out the round battery cell.
3. Replace the battery with a new one.
4. Replace the cover and snap it back into place on the remote control.
Using the remote control to record a movie
**** INSERT IMAGE HERE WITH CALLOUTS FOR START/TAG/STOP BUTTONS ***
Press the START button to start recording. The LED blinks red when the camera is recording.
Press the START button to tag any exciting moments.
To wake up the remote, press the START button for 2 seconds until the LED blinks twice in green.
Squeeze the remote, ie. press the STOP button to stop recording. The LED stops flashing red.
27