User's Manual

Tip : While the battery stick is charging, the LEDs show the charge level and one LED flashes.
To see the power level of the battery stick, remove the USB connector from the USB charging socket,
then press the START button. The LEDs light up to show the power level.
When the battery stick is charged, insert the battery stick into the camera and turn it until it locks.
Charging the camera using the optional power cable
Open the connector cap on the back of the battery stick.
NOTE TO GERRY: we need to replace this image with a cleaner one :-)
Tip : You don't have to remove the battery stick from the camera.
Connect the power cable to the battery stick connector and to a USB socket.
Inserting a memory card
The photos you take and the videos you record are stored on a micro-SD memory that is located in the
battery stick.
Inserting a micro-SD memory card into the battery stick
Important : If you remove the battery stick be extra careful not to let dirt or water enter the camera
or the battery stick. Only remove the battery stick in clean and dry conditions.
Press the battery stick release button as shown below (button 3).
6