User's Manual

Doc No： Topic：
User Manual of TomTom HD
Traffic Receiver Module 1 US
Ver：
1.1
Page：
14 / 39
Page 14 of 39
When the module is in POWER OFF mode the application interface is switched off and must not
be fed from any other source. Therefore, your application must be designed to avoid any current
flow into any digital pins of the application interface.
2.15.4 Inserted and removal action direction
These models are made very thin so that they may be smaller in size and light in weight than
before. Take care not to give then excessive force and insert by sliding when mating them
together or un-mating them. Otherwise, breakage may result. To prevent damage from incorrect
insertions please confirm the correct position before mating connection.
3. Getting Started
3.1 System requirement
The following shows the operation by PC with Microsoft Window 2000, XP or Vista. The screen
display for each procedure may be a little different for different operating system.
3.2 Driver installation
Please install “CP210x_VCP_Win2K_XP_S2K” driver on your PC before doing your Modem setting.
The driver is for Silicon Laboratories’ CP210X USB to UART Bridge chip in the device.
3.3 Modem setting
Please use “Control Panel” to install new modem.